Filter
Top Products
Introduction Chapter 1
GPIB-ENET for Macintosh 1-6 © National Instruments Corp.
The Back Panel Switches
The GPIB-ENET has a 2-position slide switch and an 8-bit DIP switch that you use to
configure the operating characteristics of the box. These switches are located on the back
panel of the GPIB-ENET, as shown in Figure 1-3.
10BASE-T AUI
87654321
ON
Figure 1-3. GPIB-ENET Back Panel
The Bottom Panel Identification Label
Figure 1-4 shows the identification label on the bottom panel of the GPIB-ENET.
Serial No. XXXXXX
Model: GPIB-ENET
P/N 1819XX-XX
REV X
Ethernet: 00:80:2F:FF:XX:XX
MADE IN U.S.A.
XXXV 50-60HZ
XXmA
FUSE: XXXmA SLOW 250V
Fuse Information
Current
Ethernet Address
Serial No. XXXXXX
AC Input
Voltage
Frequency
NATIONAL
INSTRUMENTS
®
Figure 1-4. GPIB-ENET Identification Label
The identification label lists various information about the GPIB-ENET, including the
part number, hardware revision number, and serial number. It also lists the unique
Ethernet address that was assigned at the factory.
The last line on the identification label lists the AC input voltage (100 to 120 V or
220 to 240 V), the frequency, the current, and fuse information.