Filter
Top Products
Hardware Configuration and Installation Chapter 2
GPIB-ENET for Macintosh 2-4 © National Instruments Corp.
AUI10BASE-T
AUICOAX
Figure 2-2. Default Ethernet Port Configuration Switch Setting
for Either Type of GPIB-ENET
If you want to connect an Ethernet conversion box to the AUI port, change the setting of
the switch to match that shown in Figure 2-3.
AUI10BASE-T
AUICOAX
Figure 2-3. AUI Ethernet Port Configuration Switch Setting
for Either Type of GPIB-ENET
Connect the Hardware
After configuring the switch settings on your GPIB-ENET, complete the following steps
to connect the GPIB-ENET to an Ethernet network.
Step 1. Connect the Cables
1. Connect the Ethernet cable to the GPIB-ENET and securely fasten it. Connect the
other end to your Ethernet network. Be sure to follow all IEEE 802.3 cabling
restrictions.
2. Connect the GPIB cable to the GPIB-ENET and tighten the thumb screws on
the connector. Connect the other end to your GPIB system. Be sure to follow all
IEEE 488.1 cabling restrictions, and use only shielded GPIB cables.
3. Plug the power cord into an AC outlet of the correct voltage.