Filter
Top Products
0777S20038 5-1
TROUBLESHOOTING
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK, INCLUDING
TROUBLESHOOTING.
The Slicer Will Not Start (Motor Is Not Humming)
• The machine is not plugged in.
• There is no power at the outlet. (Check by plugging in a small working appliance,
like a lamp. Check to see if a circuit breaker has tripped. If the circuit breaker has
not tripped and the circuit is still not working have a qualified electrician check the
circuit.)
• The motor switch overload has tripped. (To reset push firmly in the direction shown
on the switch nameplate.)
• There are bread crumbs in the motor starting switch. (Have a qualified electrician
disassemble the switch and clean it.)
• The switch arm on the Switch Trip Mechanism is bent. (A qualified service agent can
bend the arm to correct the problem, see the illustration below.)
• The switch trip mechanism is binding. (Clean the mechanism and lubricate its pivot
point, see above illustration.)