Filter
Top Products
0777S20039 6-10
Remove the discharge table from the slicer. Loosen, but, do not remove the two locking
cams which secure the blade frame to the swing shaft. Remove the plastic plug over the
set screw in the fixed collar, see below. Using an allen wrench, loosen, do not remove
the set screw in the fixed collar. Using a ruler, (15” maximum), measure the distance
between the blades. Gently tap the collar with a small mallet either to the right or left
until the distances between the blades are equal. When satisfied with the location
tighten the fixed collar’s set screw and replace the plastic plug. Lastly tighten the two
locking cams which secure the blade frame.
Adjusting the Clearance Between the Blade Frames
The distance between the blade frames is adjusted by rotating the eccentric pins located
above the blade frames. Two wrenches are used to do this. One wrench is used to
keep the eccentric pin from rotating while the second is used to loosen the lock nut on
the end of the pin. This nut secures the pin in position once its proper location is
determined. See the illustration below.