Filter
Top Products
0777S20039 6-11
To adjust the eccentric, once the lock nut is loosened, rotate the pin using the wrench
used to hold the pin. Rotate the pin, (it is possible that both pins will need adjustment at
the same time), until the knives of the machine are in line within a 1/32 of an inch,
(alternating blades should not appear be in front of or behind each other when viewed
from the side). It is easiest to view this alignment my placing a straight edge horizontally
along the blades midway between the ends of the blade on the blade’s dull side,
(discharge side), when the blade frames are inline or level. When the eccentric pins are
in the desired position tighten each of the lock nuts to secure the position of the
eccentrics. Check the blade frame clearance by turning the driven pulley by hand.