Filter
Top Products
0777S20039 6-1
MAINTENANCE
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Cleaning
Use a mild detergent solution to clean all exterior surfaces and empty the crumb tray
daily or more often if necessary. Periodically remove both tables and the crumb chute
and then brush, blow, (if compressed air is available), or wipe all foreign material from all
surfaces, especially from moving parts.
Lubrication
Once a month, more often during heavy use, put a drop of food approved lubricant on
each of the pivot points of the plastic links at the top to the blade frames. Also add a
drop or two of the same food approved lubricant to the switch trip mechanism pivot point,
pusher lever and yoke pivots. All other bearings are either grease packed or sealed and
seldom need attention.
NOTE
NEVER OIL OR GREASE THE MOTOR.
Removing the Blade Frames
To remove the blade frames you must first remove the infeed table, crumb chute, and
discharge table. First remove the four black knobs securing the tables, (see the
illustration below). In addition to the knobs the infeed and discharge tables are held in
place by friction so pull the infeed table straight out and hard to separate them.