Filter
Top Products
0777S20038 5-2
• The upper limit switch is not being made. (Adjust the limit switch screws as required
to correct the problem, see above illustration.)
The Slicer Will Not Start (Motor Is Humming)
CAUTION
DO NOT ALLOW THE MOTOR TO HUM WITHOUT STARTING.
THE MOTOR CAN BE PERMANENTLY DAMAGED BY OVERHEATING.
• The motor has failed. (Have it checked by a qualified electrician.)
NOTE
A SPECIAL NON-VENTILATED MOTOR MUST BE USED WITH THIS SLICER.
• The drive system is binding. (Have a qualified service agent check for defective
bearings or other restrictions to free movement.)
• There is mechanical interference between other parts of the slicer. (Have a qualified
service agent evaluate the machine for adjustment or replacement of defective
parts.)
The Slicer Starts Without Pulling the Knob
• The switch arm on the Switch Trip Mechanism is bent. (A qualified service agent can
bend the arm to correct the problem, see the illustration in the “The Slicer Will Not
Start” section above.)
The Slicer Does Not Stop When Slicing is Complete
• Either one or both of the upper and lower limit switch screws on the limit switch trip
mechanism are out of adjustment. (Adjust the limit switch screws as required to
correct the problem, see the illustration in the “The Slicer Will Not Start”, section
above.)
The Slicer Stops Before Slicing Starts or is Complete
• The lower limit switch screw on the limit switch trip mechanism is out of adjustment.
(Adjust the screw as required to correct the problem, see the illustration in the “The
Slicer Will Not Start”, section above.)
• The switch trip mechanism is binding. (Clean the mechanism and lubricate its pivot
point, see the illustration in the “The Slicer Will Not Start”, section above.)