Filter
Top Products
0777S20039 6-9
infeed and discharge tables are held in place by friction so pull the infeed table straight
out and hard to separate them.
Turn the adjustment nut, at the lower end of the motor mounting plate, counterclockwise
with a wrench to loosen the drive belt, see “Tightening the Belt” above.
Disconnect the end of the connecting rod at the rocker by removing the two cap screws
and cap as shown below. The drive belt may now be removed from the pulleys
The new belt can be installed by reversing the removal procedure. Refer to the
“Tightening the Belt” section to adjust the tension on the drive belt.
Adjusting the Blade Frames When Slices Vary in Thickness