Configuring the Hotwire DSLAM
4-6
8000-A2-GB26-00
May 1998
Configuring VLAN(s) on a DSL or MVL Card
"
Procedure
To configure at least one VLAN ID for this DSL or MVL card:
1. Select
Configuration
→
Bridge
→
Card VLAN
(A-E-B).
2. Enter 0 or press Return at the Item Number (0 to add new record):
prompt.
3. Enter the VLAN ID at the Enter VLAN ID between 1 and 4094 or
space to delete: prompt.
4. Enter enabled at the Enabled/Disabled: prompt in the Mux Fwd field.
(Default = enabled.)
5. Enter disabled at the Enabled/Disabled: prompt in the IP Filter field.
(Default = disabled.)
6. Enter enabled at the Enabled/Disabled: prompt in the IP Scoping field.
(Default = enabled.)
7. If desired, enter a domain name at the Domain Name: prompt.
8. Enter yes at the yes/no: prompt to save your changes.
NOTE:
For more information about the fields listed above, see Chapter 3,
Service Domain
, in the
Hotwire DSLAM for 8310 MVL and 8510 DSL
Cards Network Configuration Guide.
Configuring the Active VLAN on each DSL or MVL Port
"
Procedure
To configure the active VLAN on each DSL or MVL port:
NOTE:
You can configure only one active VLAN per port, but normally you assign the
same Next Hop Router.
1. Select
Configuration
→
Bridge
→
Port VLAN
(A-E-C).
2. Enter the port number at the DSL Port #: prompt.
3. Enter a to activate at the Action(Edit/Activate/Deactivate):
prompt.
4. Enter the number of the VLAN to be assigned to this port at the Input
Number: prompt. If you want a VLAN that spans several DSL or MVL cards,
you must specify the same VLAN number across all cards.
5. Press Ctrl-z and save the changes.