Filter
Top Products
20 EN
Problem Possible cause Solution
OverÁ ow. A wrong function was selected. Select a correct function.
Installation was incorrect or the
perforated Á ow cup was not
installed into place.
Make sure that the perforated
Á ow cup is correctly installed.
Soymilk is too diluted or too
many beans are added.
Put proper quantity of ingredient
as instructed in the “Use the
appliance” section.
The water level is above
ഌට໎ (the maximum level
indication) or below ༳ට໎
(the minimum level indication).
Make sure that the water level is
between ഌට໎ (the maximum
level indication) and ༳ට໎
(the minimum level indication).
The appliance is broken. Contact the Philips Consumer
Care Centre.
The overÁ ow sensor is not
cleaned.
Clean the overÁ ow sensor.
The time taken to
process soymilk
is longer than
instructed, but other
functions work well.
The voltage is too low. Use a household power
regulator.
The water temperature is
too low.
Add warm water no hotter
than 70§.
Food is burnt. A wrong function is selected. Select a correct function.
The inner side of the chamber
was not cleaned.
Clean the inner side of the
chamber.
InsufÀ cient water is added. Make sure that the water level is
between ഌට໎ (the maximum
level indication) and ༳ට໎
(the minimum level indication).
Too much ingredient is added. Put proper quantity of ingredient
as instructed in the “Use the
appliance” section.