Rangemaster 90 Ceramic Range User Manual


 
17
GB/IE
Don’t use steel wool (Brillo) or any other
materials that will scratch the surface. Don’t use
oven cleaning pads.
Removing the Oven Linings
The lining panels can be removed for cleaning
and for cleaning behind. Remove the shelves
first.
Remove the oven roof by sliding it forwards.
Each side of the oven is fixed with four fixing
screws. You don’t have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then
pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
When replacing the linings fit the side linings
first.
Make sure you fit the oven roof with the slot at
the front.
The Tall Oven
To clean the oven sides slide out the shelves,
unhook the supports from the oven sides and lift
out.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may be
required to move it. There are two
levelling rollers at the back and also two
screw down levelling feet at the front.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of the
fascia panel as you move the oven. Lift the front
of the cooker slightly and pull forward.
Do not move the oven by pulling the door
handles or knobs.
Move the oven a bit at a time, checking behind it
to make sure the supply cable is not caught.
Make sure the electricity cable has sufficient
slack to move the cooker forward as you go
along.
If a stability chain is fitted, release it as
you ease the cooker out. Don’t forget to
refit it when you replace the cooker.
When you replace the cooker, again check
behind to make sure that the electricity cable is
not caught or trapped.