Filter
Top Products
For The Electrician
Electrical connections:
Follow All Local, State & National Codes
Check the nameplate for voltage and current
requirements. An electrical cord is not supplied.
Connect the AFE325 to a separate electrical
circuit. Wiring to the machine must conform to all
codes. A licensed electrician may be required in
some situations. The electrical connection is made
in the control box inside the machine.
This unit must be grounded.
Route the electrical power cord thru the corner
post to the control box inside the cabinet.
To make the electrical connection, remove the
following parts:
•Top panel
•Bin door
•Rubber moulding
•Left moulding cover
•Left track
•Upper front panel
•Upper baffle
•Left side panel
•Front louvered panel
•Control box cover
If the machine will be started up later, after making
the electrical connections, replace all panels.
Upper Front
Panel
Bin Door
Spacer
Bin Door
Left Track
Left Moulding
Cover
Upper BaffleFront Louvered
Panel
Ice Discharge Tube
(Ref)
Top Panel
Left Side
Panel
Control Box Cover
Electrical
Inlet
Serial Number
Plate
AFE325
August 1994
Page 5