Filter
Top Products
26
A46951, SCA/SCNZ R990K(S)/(W) O/M
AC Line Voltage Single phase 230-240V, 50Hz
AC Power Required 1.6 kW (Microwave) / 1.6 kW (Convection)
Output Power
Microwave 900 W* (IEC test procedure)
Convection Heater 1500 W
Microwave Frequency 2450 MHz**(Class B/Group 2)
Outside Dimensions (WxHxD) 627mm x 378mm x 492mm 627mm x 378mm x 487mm
Depth with the door open 942mm 949mm
Turntable Diameter 390mm
Cooking Uniformity Turntable system
Weight Approx. 29 kg
SERVICE CALL CHECK
Please check the following before calling service:
1. Does the display light up? Yes No
2. When the door is opened, does the oven lamp come on? Yes No
3. Place one cup of water (approx. 250 ml) in a glass measuring cup in the oven and close the door securely.
Oven lamp should go off if door is closed properly.
Press the INSTANT COOK/START pad once.
A. Does the oven lamp come on? Yes No
B. Does the cooling fan work? Yes No
(Put your hand over the rear ventilation openings.)
C. Does the turntable rotate? Yes No
(The turntable can rotate clockwise or counterclockwise. This is quite normal.)
D. Does the COOK indicator light up? Yes No
E. After 1 minutes, is the water hot? Yes No
4. Remove water from the oven and programme the oven for 5 minutes at convection 180°C.
A. Does the CONV and COOK indicators light up? Yes No
B. After 5 minutes, is the inside of the oven hot? Yes No
If "NO" is the answer to any of the above questions, please check your wall socket and the fuse in your meter box.
If both the wall socket and the fuse are functioning properly, CONTACT YOUR NEAREST SERVICE
CENTRE APPROVED BY SHARP.
NOTE:
1. If time in the display is counting down rapidly, check Demonstration Mode. (See P. 23 for detail.)
2.
After manual or automatic cooking using the Grill, Mix or Convection modes, the cooling fan will switch on to cool the oven cavity.
To clear it, press the STOP/CLEAR key and the display will return to the time of day, if set. During these modes, the cooling fan
will carry on working after you have pressed the STOP/ CLEAR key. You may feel hot air blowing out of the ventilation openings.
SPECIFICATIONS
CARE AND CLEANING
Disconnect the power supply cord before cleaning or leave the door open to inactivate the oven.
Before cleaning ensure oven cavity is cool.
CLEAN THE OVEN AT REGULAR INTERVALS -
Keep the oven clean and remove any food deposits, or it could lead to
deterioration of the surface. This could adversely affect the life of the appliance and possibly result in a hazardous situation.
Exterior:
The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoid the use of harsh
abrasive cleaners. Keep the ventilation openings free of dust.
Door: Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth to
remove any spills or spatters. Do not use abrasive cleaner.
Touch Control Panel: Wipe the panel with a cloth dampened slightly with water only. Do not scrub or use any sort
of chemical cleaners. Avoid the use of excess water.
Interior walls:
Wipe spatters and spills with a little dish washing liquid on a soft damp cloth. For heavier stains inside the oven cavity
only, use a mild stainless steel cleaner applied with a soft damp cloth. Do not apply to the inside of the door. Wipe clean ensuring all
cleaner is removed.
After use wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashes. Built-up splashes may
overheat and begin to smoke or catch fire. Do not remove the waveguide cover.
DO NOT USE CAUSTIC CLEANERS, ABRASIVE OR HARSH CLEANSERS OR SCOURING PADS ON YOUR OVEN.
NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF YOUR OVEN.
DO NOT USE A STEAM CLEANER. Avoid using excess water. After cleaning the oven, ensure any water is remove with a soft cloth.
Note: At regular intervals, heat the oven referring to "Heating without Food" on page 10. Because, the splashed dirt
or food oil remained around oven walls may cause the smoke and odour.
Turntable/Turntable Support/Racks: Wash with mild soapy water and dry thoroughly.
Note: Keep the waveguide cover and accessories clean at all times. If you leave grease or fat in the cavity or
accessories, it may overheat, cause arching, smoke or even catch fire when next using the oven.
SPECIAL NOTE for TURNTABLE SUPPORT:
After cooking, always clean the turntable support, especially around the rollers. These must be free
from food splashes and grease. Built-up splashes or grease may overheat and cause arcing, which
may produce smoke or catch fire.
* When tested in accordance with AS/NZS 2895.1.2004
** This is the classification of ISM (Industrial, Scientific and Medical) equipment described in the International
Standard CISPR11.
Model Name R-980J R-990J(S)/R-990K(S)/R-990K(W)
roller
SCA/SCNZ R990K 14-26 05.9.6, 10:26 AM26