Filter
Top Products
10
KS-342
The routing switch sends the aux signal to the L and R main out-
put busses (AUX MIX) or to the monitor bus only (AUX MONI) or
completely off (center position).
Right side (viewed from front)
This section is chiey the outputs from the mixer:
MAIN outputs L and R Balanced XLR-3 connectors providing
the main analog output signals from the KS-342. They can also
be used to provide the outputs from input channels 1 and 2, for
example when these are used in MS mode.
MAIN level controls Use these rotary controls to adjust the
level of the signals sent from the main outputs.
MAIN compressor controls The main output busses can
be compressed using the onboard compressor (this applies
to all outputs fed by the output busses. The triggering of
the compressor can be done by either the L or the R bus, or
ST LINK setting, in which either bus can be above the trigger
level, or L•R in which both busses must be above the trigger
level (the off position is represented by the • symbol). The
trigger level itself can be set to +3 dB (3), +6 dB (6), +9 dB (9)
or +12 dB (12).
SUB output This XLR-5 connector provides the main output
busses as balanced sub outputs (or this connector can also be