Filter
Top Products
7
KS-342
NOTE
If the unit is not to be used for an extended period of time,
remove the batteries from the unit. Do not leave dead batteries
in the unit.
The batteries are contained in a standard battery holder, which
slides out for easy replacement. Additional battery holders can
be purchased and “pre-loaded” with spare batteries for easy
and speedy replacement.
Accessories, etc.
The Kamesan KS-342 is supplied with everything you need to
start work.
However, you can purchase the following, in order to increase
the capabilities and the functionality of the unit:
Power adaptors: you can use the Kamesan PS-M12 mini power
supply.
Spare battery holders, allowing you to slip in a new power
source at a moment’s notice. Use the BP-3/8 battery holder for
dry cell batteries, and the BH-1 for the NiCd NP-1 battery.
To expand the capabilities of the unit further, it is possible to t
a KS-6001 4-channel sub-mixer, and/or a KS-6002 4-channel
EQ/compressor unit, both of which integrate neatly into the KS-
342 system without the use of cables.
Consult your Kamesan supplier for details.
About the case
The Kamesan KS-342 case is designed to hold and protect the
unit against any wear and tear under the standard conditions
of use for which the mixer is designed. In addition, the mixer
itself has been designed to be rugged and to stand up to the
demands that will be made of it in its expected life.
Even so, you should not drop the mixer, or subject it to violent
shocks or vibration. Always keep the mixer in its case to avoid
any possible damage.
You can loosen the straps on the case in order to expand the
case size and allow the side strap holders on the mixer to be
freed from the retaining panels in the case.
If you remove the mixer from the case, and then replace it, al-
ways make sure the case clips (four in all) t over the lip at the
top of the mixer front panel.