Filter
Top Products
6
KS-342
Before operating the Kamesan KS-342, you should be aware of
the following points:
All XLR-3 connectors (male and female) are wired with the fol-
lowing pinouts: 1=ground, 2=hot, 3=cold.
The AC adaptor jack is a tip-negative connection. DO NOT at-
tempt to make any connection to this jack except using AC
adaptors authorized by Kamesan.
Always remove any dead batteries immediately from the
Kamesan KS-342, and remove any batteries from the unit if it
will not be used for some time. Corroded and leaking batteries
can cause severe damage to the unit.
About the manual
Keep this manual in a convenient location for handy reference.
Any labels on the unit mentioned in the manual are shown this
typeface: OUTPUT.
Sometimes you will see a note—important information which
you should note.
NOTE
Failure to read and observe notes and warnings may result in
personal injury and/or possible damage to the unit.
Batteries and power
The Kamesan KS-342 can use any standard type of battery:
manganese, alkaline, nickel-cadmium, nickel-hydride cells t-
ted in a BP-3/8 battery holder (supplied with the KS-342) or a
special NP-1 NiCd battery pack.
Eight type 3 (AA) size batteries are required.
In normal use and temperature conditions, a set of alkaline bat-
teries provides about six hours of operation. See the specica-
tions at the end of this manual for more detailed information.
In addition, the Kamesan KS-342 can accept power from a
suitable power adaptor connected to the DC power input. This
power should be between 10 V and 15 V DC, with a maximum
current of 500 mA. The connector is tip negative.