Smeg ADP8242 Dishwasher User Manual


 
The First Wash
Switching on
10
The dishwasher must not be turned on until the dishes have been loaded, the dispenser has
been filled with detergent, a check has been made that the spray arms turn freely, and the door
has been shut. The water tap must also be turned on and salt placed in the container.
After carrying out all the operations described in the previous points, proceed as follows:
a) press the start button A and wait for the programmes light to come on;
b) press the program selector button C several times, until the light corresponding to the
program of choice illuminates;
c) close the door. The appliance will start the washing program automatically after the beep.
Switching off
At the end of the program, the dishwasher emits a short beep and the light of the program just
completed flashes. To switch off the appliance, open the door and press the start button.
Changing the programme
To change a program in progress, after opening the door press the program selection button for
a few seconds until the lights of programs 4 and 5 illuminate simultaneously. After about 1
minute, the dishwasher switches to the end of the cycle.
CAUTION! If the door is opened while washing in progress, it is essential to wait at least 1
minute with the door almost closed before restarting the dishwasher.
Annulling program
To annul a program in progress, after opening the door press the program selection button for a
few seconds until the lights of programs 4 an 5 illuminate simultaneously.
After about 1 minute, the dishwasher switches to the end of the cycle.
Removing the dishes
It is better to wait at least 20 minutes after the end of the program before removing the dishes,
so that they will be dry and not too hot.
Empty the bottom basket first, so that any drops of water left in the top basket will not fall onto
dishes still in the bottom one.