Smeg ADP8242 Dishwasher User Manual


 
How to Deal with Small Problems 1
3
If the dishwasher is to be out of use for a long period
The following precautions must be taken:
- perform two consecutive pre-rinses;
- disconnect the plug from the mains;
- leave the door slightly open so that no unpleasant smells can form;
- turn off the water tap.
Before re-using the dishwasher after a lay-off
- Re-connect the plug to the power socket;
- check that no sludge or rust has been deposited in the water supply pipeline;
- allows water to flow freely from the supply tap for a few minutes;
- re-connect the filter hose and turn the water tap back on.
The dishwasher is able to signal a series of a malfunctions by illuminating more than one light
simultaneously; the key to these signals is as follows:
E1
E2
E3
E4
E5
E6
The anti-flooding signal has been tripped (for
models fitted with AQUASTOP device only).
This alarm is only tripped if water leaks from the
dishwasher. The after-sales service must be called on.
The dishwasher has loaded too much water and the
safety level switch has been tripped.
Repeat the cycle. If the problem persists, contact the
after-sales service.
The dishwasher is unable to heat the water.
Repeat the cycle. If the problem persists, contact the
after-sales service.
The temperature monitoring system has failed.
Switch the dishwasher OFF, switch it back on and
restart the washing program. If the alarm recurs, call the
after-sales service.
The dishwasher is unable to take in water.
Check the intake hose for kinks and ensure that the
siphon is not blocked or the filters fouled.
The dishwasher is unable to discharge the water
from the tank.
Check the intake hose for kinks and ensure that the
siphon is not blocked or the filters fouled.
- led on
- led off
- flashing led
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
In case of E1, E2, E3 and E4, the washing program must be set again to continue.
In case of E5 and E6, simply open and close the door to continue (once the cause of
the fault has been illuminated).