Filter
Top Products
SFG10E ELECTRIC SURFACE GRINDER — OPERATION AND PARTS MANUAL — REV. #1 (07/16/07) — PAGE 22
FIGURE 28
4) Return the SURFACE GRINDER to its normal operating
position.
5) If the machine is to be used immediately, reconnect
the extension cord or SURFACE GRINDER from the
power source. Determine that the ON/OFF switch located
on the operator handle is in the OFF position.
DANGERDANGER
DANGERDANGER
DANGER
UNEXPECTED MACHINE START UP CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL INJURY.
TRANSPORTING THE SURFACE GRINDER
The SURFACE GRINDER has an operational weight that
prohibits one person from loading and/or unloading it alone
by conventional, physical efforts.
DANGERDANGER
DANGERDANGER
DANGER
DO NOT ATTEMPT TO LIFT THE SURFACE GRINDER
UP INTO A TRANSPORTATION VEHICLE WITH THE
USE OF ONE PERSON ALONE. DO NOT ATTEMPT
TO LOWER THE SURFACE GRINDER FROM A TRANS-
PORTATION VEHICLE WITH THE USE OF ONE
PERSON ALONE. LIFT AND/OR LOWER THE SUR-
FACE GRINDER ONLY BY THE USE OF A POWER
TAILGATE UNIT, A SUITABLE HOIST UNIT OF
PROPER CAPACITY AND/OR CONFIGURATION OR
BY THE USE OF A PROPER QUANTITY OF PERSON-
NEL IN PROPER PHYSICAL CONDITION.
Do not utilize excessive force when removing a multi-
accessory attachment with the pry bar. Excessive
force can result in damage to the aluminum disc.
Proper removal techniques by both methods will
result in minimal damage to the aluminum disc.
CAUTION
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
1) A lifting bail device can be used to facilitate lifting by a
mechanical device incorporating a chain and suitable
attachment device. The location of the lifting bail may
not always locate the exact position of the center of
gravity for the SURFACE GRINDER. Lifting handles are
also provided on both sides of the transmission case.
These handles can be utilized by personnel whenever
lifting/lowering the SURFACE GRINDER or as
attachment points for a chain sling whenever a suitable
hoisting device is utilized. FIGURE 29.
ASSEMBLY INSTRUCTIONS/OPERATIONS
REMOVING A MULTI-ACCESSORY ATTACHMENT (not
including multi-segmented, dry diamond discs) FROM THE
ROTATING DISC
Tools Required:
1 Small Hammer
1 Drift Punch or Small Pry Bar
DANGERDANGER
DANGERDANGER
DANGER
WHEN REMOVING A MULTI-ACCESSORY ATTACH-
MENT FROM THE SURFACE GRINDER, ALWAYS
WEAR APPROPRIATE SAFETY EYEWEAR AND AP-
PAREL TO MINIMIZE THE POTENTIAL FROM FLYING
DEBRIS. FLYING DEBRIS CAN RESULT IN PROP-
ERTY DAMAGE AND/OR PERSONAL INJURY.
1) Disconnect the extension cord or SURFACE GRINDER
from the power source.
2) Tilt the SURFACE GRINDER back until the operator
handle comes in contact with the surface. Appropriate wheel
chocks are recommended.
3) The multi-accessory attachment can be removed by
both the use of a drift punch or small, pry bar. If utilizing the
drift punch, strike the narrow end of the mounting wedge
with controlled, direct blows until the attachment is released
from the aluminum disc. If utilizing the pry bar, position the
bar between the aluminum disc and the attachment. Use
controlled, direct blows to the bar in order to force the
attachment loose from the aluminum disc. FIGURE 28.