Filter
Top Products
Steam Wetness or Steam Pump Rate
The steam pump rate of this espresso
machine has been pre-set. Modifying the
steam pump rate enables you to make the
steam wetter or dryer and aids in the delivery
of a powerful, dry steam – ideal for texturing
milk. The steam pump rate can be modified
in flow rate increments up or down should it
be desired.
To do this you need to follow the instructions
below:
1. Insert the power cord into a 230-240V
AC power outlet and switch the power
‘ON’ at the mains only, so that no lights
are illuminated on the espresso machine
control panel (ie. the power outlet should
be 'ON' but the espresso machine will be
'OFF').
2. Press and hold down the ‘HOT WATER’
button for 3 seconds.
3. While still holding down the ‘HOT WATER’
button briefly press the ‘POWER’ button
and release.
4. Release the ‘HOT WATER’ button.
Note: This activates the programmability
of the steam pump rate and to signal this
the machine will output the current setting
with a sequence of beeps. See chart below
to determine what setting your machine is
programmed to.
Advanced Programming Options (continued)
Note: The lights behind the 'COFFEE' and
'STEAM' buttons will start flashing.
5. Within 30 seconds press and release one
of the flashing buttons depending on the
required flow rate adjustment;
Up (+) a setting : Press 'STEAM'
Down (-) a setting : Press 'COFFEE'
Note: When you have selected a new pump
rate setting the machine will sound a
sequence of beeps to indicate the new pump
rate setting.
6. To save your settings press and hold down
the 'HOT WATER' button for 3 seconds. A
single long beep will sound to indicate your
settings have been saved.
Note: The espresso machine will then
automatically power on and begin heating up.
Note: The machine will stay in programming
mode for up to 30 seconds. If you do not
select a new pump rate setting within 30
seconds the program will automatically return
to the Factory Setting and the espresso
machine will then power on and begin
heating up.
Down (-)
Up (+)
Beep Sequence Setting
3 short beeps
2 short beeps
1 short beep
1 short and 1 long beep
1 long beep
2 long beeps
3 long beeps
+ 3
+ 2
+ 1
Factory Setting
- 1
- 2
- 3
28