Sunbeam EM5900 Coffeemaker User Manual


 
Using the control panel
Power
Press the ‘POWER’ button once to turn the
espresso machine on. The light behind the
‘POWER’ button will illuminate green and
start flashing; this is to indicate that your
espresso machine is on and is heating up.
Ready Mode
When the green light behind the ‘POWER’
button stops flashing and turns to a constant
red light, this indicates that the espresso
machine is heated and ready to use. The
lights behind the 'COFFEE', 'STEAM' and
'HOT WATER' buttons will show a constant
green light. The machine is now in Ready
Mode as represented below.
Note: Remember that if the light behind
the ‘POWER’ button is flashing it means
the espresso machine is adjusting the
temperature of the heating system.
To turn the espresso machine off, simply
press the ‘POWER’ button, the red power
light and all other lights on the control panel
will turn off.
Espresso
The ‘COFFEE’ button allows the coffee maker
to have complete control over the length of
the espresso pour.
Once the espresso machine is switched on
and heated, so the machine is in ready mode
(see above), the coffee maker is able to use
the espresso coffee operation. The coffee
maker simply needs to press the ‘COFFEE’
button once to start the pour and press again
to stop.
Note: Before activating the espresso coffee
function ensure that the steam and hot water
control dial is in the OFF position.
Important: Once the espresso coffee operation
is activated, before the espresso pour starts
the progressive pre-infusion feature will
release three short bursts of gradual water
pressure onto the coffee cake. After this
the full water pressure is applied and the
espresso will pour freely.
Note: When the coffee maker has activated
the espresso coffee operation the lights
behind the 'STEAM' and 'HOT WATER'
buttons will go off. The lights behind the
‘POWER’ and ‘COFFEE’ buttons will remain
on.
Note: Once the espresso coffee operation has
been activated the light behind the ‘POWER’
button will flash until the temperature of the
heating system is correct. Once at the correct
temperature the light will remain lit and the
espresso pour will start.
I@@
7