Filter
Top Products
Using the processing bowl attachment with the
slicing/shredding disc
1. Place the processing bowl on the non-slip
mat, ensuring the surface is clean and
level.
2. Fit the shredding/slicing disc with the
spindle into the processing bowl.
3. Attach the lid onto the processing bowl and
rotate the lid in a clockwise direction until
it locks into position.
4. Insert the motor housing into the hole on
the top of the processing bowl attachment
until you hear a click. See Figure 5.
5. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
6. Remove the food pusher and place
ingredients into the feed tube. Using the
food pusher guide food down the feed tube
evenly, while operating the power button
with the other hand.
7. Select the optimal speed for the processing
task by turning the speed control dial from
1 to 5 and then depressing the power
button (I). Speed one on the speed control
dial is the slowest and speed five is the
fastest.
Note: All stick blenders are designed to
operate only whilst the power buttons remain
depressed.
8. For an extra boost of power during
operation, the turbo speed button (II) may
be depressed.
Note: The power button (I) should be released
when selecting the turbo speed button (II).
9. To stop the stick blender, take your finger
off the power button or turbo speed button.
10. To detach the processing bowl
attachment, push the buttons at either side
of the base of the motor housing until the
two pieces separate. See Figure 6.
Using your StickMaster stick blender continued
8
Figure 5
Figure 6