Filter
Top Products
Using the processing bowl
Using the processing bowl with the chopping
blade
1. Place the processing bowl on the non-slip
mat, ensuring the surface is clean and
level.
2. Fit the stainless steel chopping blade into
the processing bowl.
3. Place food into the processing bowl.
4. Attach the lid onto the processing bowl and
rotate the lid in a clockwise direction until
it locks into position.
5. Insert the motor housing into the hole on
the top of the processing bowl attachment
until you hear a click. See Figure 3.
6. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
7. Hold the bowl with one hand while
operating the power button with the other.
Select the optimal speed for the processing
task by turning the speed control dial from
1 to 5 and then depressing the power
button (I). Speed one on the speed control
dial is the slowest and speed five is the
fastest.
Note: All stick blenders are designed to
operate only whilst the power buttons remain
depressed.
8. For an extra boost of power during
operation, the turbo speed button (II) may
be depressed.
Note: The power button (I) should be released
when selecting the turbo speed button (II).
9. To stop the stick blender, take your finger
off the power button or turbo speed button.
10. To detach the processing bowl
attachment, push the buttons at either
side of the base of the motor housing
until the two pieces separate.
See Figure 4.
Using your StickMaster stick blender continued
Figure 3 Figure 4
7