Filter
Top Products
10
Using your StickMaster stick blender continued
Using the milk frothing attachment
1. Insert the milk frothing attachment onto
the base of the motor housing until you
hear a click. See Figure 9.
2. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
3. Holding the stick blender, lower the milk
frother into milk. Select speed 1 on the
speed control dial, and then depress the
power button (I).
Note: All stick blenders are designed to
operate only whilst the power buttons remain
depressed.
Frother attachment should not be lifted from
the milk while in operation.
4. To stop the stick blender, take your finger
off the power button.
5. To detach the milk frother attachment,
push the buttons at either side of the base
of the motor housing until the two pieces
separate. See figure 10.
Note: Please ensure to use a large enough
jug when frothing as milk may splash. Milk
volume can increase by up to 3-4 times
of the original volume. A tall deep jug is
recommended over a short shallow jug. Fat
content and temperature of the milk will
affect the way it froths.
Note: Frother should not be used with hot
liquids.
Figure 9
Figure 10