Filter
Top Products
9
Model 490 Important: To the Operator
Section 5 Important: To the Operator
Indicator Lights:
“Add Mix” / “Mix Out”
The “Mix Low” light is located on the front of the
machine. When the light is flashing, it indicates that
the mix hopper has a low supply of mix and should
be r efilled as soon as possible. The Model 490
utilizes a “ Mix Out” light. When flashing, it indicates
there is no mix in the hopper and the compressor
stops running until mix is replenished. This
eliminates possible damage to the beater, blades,
drive shaft and door.
Overload Mechanism
The overload mechanism pr otects the beater motor
from an overload condition. Should an overload
occur, the overload mechanism will discontinue
machine operation. To properly r eset the freezer,
place the control switch in the “ OFF” position. Allow
the unit to cool. Place the c ontrol s witch in the
“WASH” position and observe the freezer's
performance.
Note: If an ov erload condition occurs while the unit
is operating in the “AUTO” mode, the unit will not
return to the “AUTO” mode once the ov erload has
reset. The draw handle must be lifted before the unit
will r eturn to AUTO. Likewise, if power is restored to
a unit following a power interruption, it is necessary
to raise the draw handle to resume “ AUTO”
operation.
The overload is inherent in the beater motor. There
is no manual reset.