Filter
Top Products
4
Model 490To the Operator
070112
Section 2 To the Operator
The freezer you hav e purchased has been carefully
engineered and manufactured to give y ou
dependable oper ation. The Taylor M odel 490, when
properly operated and cared for, will produce a
consistent quality product. Like all mechanical
products, it will require c leaning and maintenance. A
minimum amount of c are and attention is necessary
if the oper ating pr ocedures outlined in this manual
are followed closely.
The Operator's Manual should be read before
operating or performing any maintenance on your
equipment.
The Model 490 will NOT eventually compensate and
correct for any errors during the set-up or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is s trongly
recommended that personnel responsible for the
equipment's operation, both as sembly and
disassembly, sit down together and go through
these procedures in order to be properly trained and
to make s ure that no misunderstandings exist.
In the ev ent y ou should require technical as sistance,
please contact your local authorized Taylor
Distributor.
Note: Warranty is valid only if the parts are
authorized Taylor parts, purchased from an
authorized Taylor Distributor, and the r equired
service work is provided by an authorized Taylor
service technician. Taylor reserves the right to deny
warranty claims on equipment or par ts if
non-approved par ts or refrigerant were installed in
the machine, syst em modifications were performed
beyond factory recommendations, or it is determined
that the failure was caused by neglect or abus e.
Note: Constant research results in steady
improvements; therefore, information in this
manual is subject to change without notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this pr oduct is
compliant with the E U Directive as well as other
similar legislation in effect after August 13, 2005.
Therefore, it must be collected separately after its
use i s completed, and cannot be dis posed as
unsorted municipal waste.
The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local code.
For additional information regarding applicable local
laws, please c ontact the m unicipal facility and/or
local distributor.
Compressor Warranty Disclaimer
The refrigeration compressor(s) on this machine ar e
warranted for the term indicated on the warranty
card accompanying this machine. However, due to
the Montreal Protocol and the U.S. Clean Air Act
Amendments of 1990, many new refrigerants are
being tested and developed, thus seeking their way
into the s ervice industry. Some of these new
refrigerants are being advertised as dr op-in
replacements for numerous applications. It should
be noted that, in the event of ordinary service to this
machine's refrigeration system, only the refrigerant
specified on the affixed data label should be
used. The unauthorized us e of alternate refrigerants
will v oid your compressor warranty. It will be the
owner's responsibility to make this fact known to any
technician he employs.
It should be noted, that Taylor does not warrant the
refrigerant used in its equipment. For example, if the
refrigerant is lost during the course of or dinary
service to this machine, Taylor has no obligation to
either supply or provide its replacement either at
billable or unbillable terms. Taylor does hav e the
obligation to r ecommend a suitable replacement if
the original refrigerant is banned, obsoleted, or no
longer available during the five y ear warranty of the
compressor.
Taylor will c ontinue to monitor the industry and test
new alternates as they are being developed. Should
a new alternate prove, through our testing, that is
would be accepted as a drop-in replacement, then
the above disclaimer would become null and void.
To find out the c urrent status of an alternate
refrigerant as it relates to your compressor warranty,
call the Taylor Distributor or the Taylor Factory. Be
prepared to pr ovide the Model/Serial Number of the
unit in question.