Filter
Top Products
1
Model 490 To the Installer
081208
Section 1 To the Installer
The following ar e general installation instructions.
For complete installation details, please see the
check out card.
Installer Safety
In all areas of the wor ld, equipment should
be ins talled in accordance with existing local codes.
Please contact your local authorities if you hav e any
questions.
Care should be taken to ensure that all basic safety
practices are f ollowed during the installation and
servicing ac tivities related to the installation and
service of Taylor equipment.
S Only authorized Taylor service personnel
should perform installation and repairs on
the equipment.
S Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
S Authorized service personnel must ensure
that the proper P PE is available and worn
when r equired during installation and
service.
S Authorized service personnel must remove
all m etal jewelr y, rings, and watches before
working on electrical equipment.
The main power supply(s) to the freezer
must be dis connected prior to performing any
repairs. Failure to follow this instruction may result in
personal injury or death from electrical s hock or
hazardous moving parts as well as poor
performance or dam age to the equipment.
Note:Allrepairsmustbeperformedbyan
authorized Taylor S ervice Technician.
This unit has many sharp edges that can
cause severe injuries.
Site Preparation
Review the area wher e the unit will be installed
before unc rating the unit. Make s ure all possible
hazards to the user or equipment have been
addressed.
For Indoor Use Only: This unit is designed to
operate indoors, under normal am bient
temperatures of 70_-75_F(21_-24_C). The freezer
has successfully performed in high ambient
temperatures of 104_(40_C) at reduced c apacities.
This unit must NOT beinstalledinanarea
where a water jet or hose c an be used. NEVER us e
a water jet or hose to rinse or clean the unit. Failure
to follow this instruction may r esult in electrocution.
This unit must be installed on a level s urface
to avoid the hazard of tipping. Extreme care should
be taken in moving this equipm ent for any reason.
Two or more persons are required to safely move
this unit. Failure to comply may result in personal
injury or equipment damage.
Uncrate the unit and ins pect it for damage. Report
any damage to y our Taylor Distributor.
This piece of equipment is made in the US A and has
USA sizes of hardware. All m etric conversions are
approximate and vary in size.