Filter
Top Products
11
Model 490 Operating Procedures
090807
If blades are in good condition, install the scraper
blade c lips on the scraper blades. Place the rear
scraper blade over the r ear holding pin on the beater
(knife edge to the outside). Holding the r ear blade on
the beater, slide the assembly into the freezing
cylinder halfway, tail end first. Install the front
scraper blade over the front holding pin. Slide t he
beater assembly completely into the freezing
cylinder.
Figure 6
Make sure the beater assembly is in position ov er
the drive s haft. Turn the beater slightly to be certain
that the beater is properly seated. When in position,
the beater will not protrude beyond t he front of the
freezing cylinder.
Figure 7
Step 3
Install the draw valve. Slide the two o-rings into the
grooves on the draw valve and lubricate the bottom
1/2 of the valve.
Figure 8
Lubricate the inside of the freezer door spout, top
and bottom, and insert the draw valve into the
freezer door from the top. It will be nec essary to
rotate the draw valve to the right when assembling
the door to the freezer.
Figure 9