Filter
Top Products
19
Model C300 NP Operating Procedures
Step 8
Insert the draw valve into the door.
11320
Figure 13
Step 9
Rotate the draw valve so the groove on the top of
the draw valve is perpendicular to the door face.
90
11261
Figure 14
Step 10
Insert the ice buster through the door spout and into
the slot located just above the lower o-ring.
11262
Figure 15
Step 11
With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock
the ice buster in place. With the draw handle in
place, install the draw handle pin. Close the draw
valve by moving the handle to the left.
11322
Figure 16
Step 12
Install the draw valve spring, pin, and cap.
11323
Figure 17