Filter
Top Products
23
Model C302 Operating Procedures
Step 14
Install the prime plug. Place the two o-rings on the
prime plug and lightly lubricate.
Figure 20
Figure 21
Step 15
Place the large o-ring into the door groove and
lightly lubricate.
Figure 22
Note: Every four months or less, discard the o-rings
and install new o-rings.
Step 16
Install the front bearing. Do not lubricate the front
bearing.
Figure 23
Step 17
Install the freezer door. Position the door on the four
studs on the front of the freezing cylinder. Firmly
push the door into place. Install the four handscrews
on the studs and finger-tighten them equally in a
criss-cross pattern to insure that the door is snug.
Do not over-tighten the handscrews.
Figure 24
Step 18
Repeat Steps 1 through 17 for the other freezing
cylinders.