Filter
Top Products
35
Model C713 Important: Operator Checklist
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
4. The mix in the hopper is
too warm.
a. Hopper cover is not in
position.
a. Clean and sanitize hopper
cover and place in
position.
28
b. The hopper temperature is
out of adjustment.
b. Call an authorized service
technician.
---
5. The mix in the hopper is
too cold.
a. The hopper temperature is
out of adjustment.
a. Call an authorized service
technician.
---
6. M ix Low and Mix Out
probes are not
functioning.
a. Milkstone build-up in the
hopper.
a. Clean hoppers thoroughly.
31
7. P roduct is collecting on
top of the freezer door.
a. The top o-ring on draw
valve is improperly
lubricated or worn.
a. Lubricate properly or
replace the o-ring.
25
8. Excessive mix leakage
from the bottom of door
spout.
a. Bottom o-ring on draw
valve is improperly
lubricated or worn.
a. Lubricate properly or
replace the o-ring.
25
9. Excessive mix leakage
into the long drip pan.
a. The seal on drive shaft is
improperly lubricated or
worn.
a. Lubricate properly or
replace the seal.
22
b. The seal is installed
inside-out on the drive
shaft.
b. Install correctly.
22
c. Inadequate lubrication of
the drive shaft.
c. Lubricate properly.
22
d. The drive shaft and beater
assembly work forward.
d. Call an authorized service
technician.
---
e. Worn rear shell bearing. e. Call an authorized service
technician.
---
f. Gear box out of alignment. f. Call an authorized service
technician.
---
10. The drive shaft is stuck in
the drive coupling.
a. Mix and lubricant collected
in drive coupling.
a. Brush clean the rear shell
bearing a rea regularly.
31
b. Rounded corners of d rive
shaft, drive coupling, or
both.
b. Call an authorized service
technician.
---
c. Gear box is out of
alignment.
c. Call an authorized service
technician.
---