Filter
Top Products
34
Models C708 & C716Operating Procedures
Step 13
Slide the large black o-ring and the two smaller
black o-rings into the grooves on the drive shaft.
Thoroughly lubricate the o-rings and s haft. DO NOT
lubricate the hex end of the shaft. (See Figure 42.)
Figure 4 2
Step 14
Install the hex end of the drive shaft into the drive
hub at the r ear wall of the mix hopper.
(See Figure 43.)
Figure 4 3
Note: For ease i n installing the pump, position the
ball crank of the drive shaft in the 3 o’clock position.
Repeat these steps for the other side of the
Model C716.
Sanitizing
Step 1
Prepare two gallons (7.6 liters) of an approved 100
PPM sanitizing solution (example: Kay-5r). USE
WARM WATER AND FOLLOW THE MANUFAC-
TURER’S SPECIFICATIONS.
Step 2
Pour the two gallons ( 7.6 liters) of sanitizing solution
over all the par ts in the bottom of the mix hopper
and allow it to flow i nto the freezing cylinder.
(See Figure 44.)
Figure 4 4
Note: You have just sanitized the mix hopper and
parts; therefore, be sure your hands ar e clean and
sanitized before going on in these instructions.
Step 3
While the solution is flowing into the freezing
cylinder, take particular care to brush-clean the m ix
level sensing probe on the bottom of the hopper, the
mix hopper, the mix inlet hole, the air/mix pump, the
pump clip, the mix feed tube, and the locking clip.