Filter
Top Products
47
Models C708 & C716 Important: Operator Checklist
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
6. The p roduct is too soft. a. Draw rate is s et too fast. a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
14
7. The p roduct is too thick. a. Freezing cylinder not
primed correctly.
a. Drain the freezing cylinder
and reprime the machine.
36
b. Air/mix pump incorrectly
assembled.
b. Follow a ssembly
procedures carefully.
31
c. The viscosity control is set
too cold.
c. Call an authorized service
technician.
---
d. Freeze-up in mix inlet
hole.
d. Call an authorized service
technician.
---
e. Butterfat is in the pum p. e. Disassemble , clean and
reinstall the pump.
31, 34, 41
8. The mix in the hopper is
too warm.
a. Hopper cover is not in
position.
a. Clean and s anitize hopper
cover and place in
position.
37
b. The agitator is not
installed.
b. Clean and s anitize the
agitator and ins tall.
37
c. The hopper temperature is
out of adjustment.
c. Call an authorized service
technician.
---
9. The mix in the hopper is
too cold.
a. The hopper temperature i s
out of adjustment.
a. Call an authorized service
technician.
---
10. Mix Low and Mix Out
probes are not
functioning.
a. Milkstone build-up in the
hopper.
a. Clean hoppers thoroughly.
42
11. Product is collecting on
top of the freezer door.
a. The top o-ring on draw
valve is improperly
lubricated or wor n.
a. Lubricate properly or
replace the o-ring.
30
12. Excessive mix leakage
from the bottom of door
spout.
a.Bottomo-ringondraw
valve is improperly
lubricated or wor n.
a. Lubricate properly or
replace the o-ring.
30