Filter
Top Products
40
Models C708 & C716Operating Procedures
Step 3
When the flow of p roduct stops, touch the WASH
and PUMP symbols
, cancelling the WASH
and PUMP modes. Close the draw valve.
Step 4
Remove the locking clip, mix feed tube, pump c lip
and the a ssembled air/mix pump.
Repeat these steps for the other side of the
Model C716.
Rinsing
Step 1
Pour two gallons (7.6 liters) of cool, clean water i nto
the mix hopper. With the white hopper brush, scrub
the mix hopper, mix level s ensing probe and the
outside of the agitator drive shaft housing. Using the
double ended brush, brush clean the mix inlet hole.
(See Figure 56.)
Figure 5 6
Note: Do not brush clean the mix inlet hole while
the machine is in the WASH mode.
Step 2
With a mix pail beneath the door spout,(s) open the
draw valve and touch the WASH symbol
.
(See Figure 57.)