Teka TR 620 Cooktop User Manual


 
25
GB
4 On model TR 735 AB, if once the second
circuit is in operation you then wish to
activate the third circuit, touch the sen-
sor (6) once again. Once you have
done this, the second pilot light (10) will
come on.
Models TT 630, TC 620 and TR 641:
The double circuit may be activated or de-
activated by touching the sensor (6) at
any time, providing the hotplate is swit-
ched on.
DISCONNECTING / TURNING OFF THE
DOUBLE HOTPLATE
1 The hotplate that you want to disconnect
has to be already activated. The decimal
point (13) must be lit.
2 Touch the double hotplate's sensor
(6). The pilot (10) will go off, and the out-
side ring will be disconnected.
DISCONNECTING / TURNING OFF THE
TRIPLE HOTPLATE (MODEL TR735 AB)
1 Touch the sensor (6). The first pilot
light (10) will go off, and the third ring will
be disconnected.
2 If you touch the sensor (6) once again
the second pilot light (10) will go off and
the second ring will be disconnected.
Only the first circuit will remain on.
Locking the Hob's Sensors
To avoid the controls being tampered with,
you can block the entire unit, except for
the on/off sensor, using the locking sensor
(9), (except on models TT 600, TB 600,
TT 630, TR 600, TC 620, TR 735 AB, TR
641 and TM 601 - see next section). This
feature is useful as a child-safety device.
When locking is enabled, the pilot light
(12) is lit.
If you use the on / off sensor to turn the ap-
pliance off when locking is activated, the
appliance will still be locked when you turn
the appliance back on again.
SAFETY FUNCTION (only models TT
600, TB 600, TR 600, TT 630, TC 620, TR
735 AB, TR 641 and TM 601 )
The safety function can be enabled after
the hob is connected. To do so, touch sen-
sor (1) to enable the touch control. Im-
mediately touch sensor (4) for five se-
conds. An L (for 'Locked') will appear on
the displays. The touch control will be swit-
ched off after a few seconds. If the cooking
area is hot, an L and an H will appear al-
ternately on the corresponding display.
This needs to be done within 5 seconds
after the touch control is activated, with no
sensor other than those indicated being
touched during that time, or the locking will
not be carried out.
The electronic control will remain locked
until the user unlocks it, even after the con-
trol is disconnected using the on/off sensor
or when restarting after there has been a
power cut.
Unlocking for cooking (only models
shown in figure 8)
To unlock the control and use it, touch sen-
sor (1) to enable the touch control. Im-
mediately touch, at the same time, the two
sensors to the right or, on models TR
735 AB and TT 630, to the left. The L va-
nishes from the display and an 0 appears
with the lower point flashing, or a H and an
0 appear alternately if the corresponding
hotplate is hot, and the hob will be ready to
use for cooking. When you disconnect the
control with the on/off sensor (1) the