Filter
Top Products
Viewing / Changing the programmed
time
To view on the clock indicator (8) the time
left before the hotplate turns off, you only
have to select the hotplate required, both
the decimal point (13) and the control pilot
light (11) which corresponds to the selec-
ted hotplate will turn on.
If you wish to change the time left, follow
the steps below:
1 The hotplate that is to be controlled must
have already been selected. Both the
decimal point (13) and the control pilot
(11) which corresponds to the selected
hotplate must be on.
2 Touch the clock sensor (7). The deci-
mal point (13) for the clock will come on.
3 Use the or sensors (5/4) to alter
the time.
Alternatively you can directly touch the
clock sensor (7) various times until the
control pilot (11) for the hotplate required
comes on. You can then also change the
time, if required, using the sensors or
(5/4).
Disconnecting the clock
When the time that was programmed for
the hotplate elapses, a series of beeps will
sound for at least a minute.
To stop the beeping, touch any sensor.
The hotplate will now be disconnected.
If you wish to stop the clock before the
time programmed has elapsed:
1 The hotplate that is to be controlled must
have already been selected. The deci-
mal point (13) and the pilot light for the
selected hotplate (11) must be on.
2 Touch the clock sensor (7). The deci-
mal point for the clock (13) will come on.
3 Use the sensor (4) to decrease the
time to 00.
Quick switch-off
Repeat steps 1 and 2 above.
3 Touch sensors and (5 and 4) si-
multaneously and the clock will be dis-
connected.
The clock will have been cancelled, but the
hotplate will still be active until you switch
it off.
MODELS TC 620, TR 735 AB AND TR 641
On these models, you can use the clock as
a countdown timer for periods between 1
and 99 minutes, and as a hotplate timer for
times between 1 and 99 minutes. All the
cooking areas can be programmed inde-
pendently and simultaneously.
Timing a hotplate
1 The cooking area to be timed has to be
selected. The corresponding decimal
point (13) must be lit.
2 Select a power level of between 1 and 9
using the or sensors (5-4).
3 Touch the clock sensor (7). The deci-
mal point (13) of the time display (8)
(which shows 00) will come on, and it
will flash on and off along with the con-
trol display (11) of the corresponding
area.
4 Touch the clock sensor (7) again to
increase the value of the time you wish
GB
28