Filter
Top Products
Important Installation Information
GAS type verification
Verify the type of gas supplied to the location. Ensure
that the appliance is connected to the type of gas for
which it is certified. Ranges are certified for use with
only natural gas or propane (LP) gas. Make certain the
range matches the gas type available; these ranges
are NOT convertible between gas types.
Important
• A backguard must be utilized when there is less
than a 12” horizontal clearance between combus-
tible materials and the back edge of the range. The
Thermador Low Back backguard must be or-
dered separately and installed at the rear of the
range. For island installations and other installa-
tions with more than 12” clearance, an optional
stainless steel Island Trim is available to cover the
backguard mounting flanges.
• Verify that the appliance is correct for the type of gas
being provided. Refer to Step 5 on Page 12 before
proceeding with the installation.
Gas Supply:
Natural Gas – 6 inch water column. (14.9 mb) min.,
14 inch (34.9 mb) maximum
Propane Gas – 11 inch water column. (27.4 mb) min.,
14 inch (34.9 mb) maximum
Electric Power Supply:
30" Model:
4 Burners - 120 VAC, 60 Hz., 1Ph., 10 Amp circuit.
36" Models:
6 Burners – 120 VAC, 60 Hz., 1Ph., 10 Amp circuit.
4 Burners with Grill – 120 VAC, 60 Hz., 1Ph., 10 Amp circuit.
4 Burners with Griddle – 120 VAC, 60 Hz., 1Ph., 20 Amp
circuit.
This appliance has been tested in accordance with
ANSI Z21.1, Standard for Household Cooking Appli-
ances (USA) and in accordance with CAN 1.1-M81
Domestic Gas Ranges (Canadian).
It is
strongly recommended that this appliance be
installed in conjunction with a suitable overhead vent
hood. (See Step 1 for Ventilation Requirements.) Due
to the high heat capability of this unit, particular atten-
tion should be paid to the hood and duct work instal-
lation to assure it meets local building codes.
Refer to the Backguard Installation instructions
on page 14, for the correct backguard models that
are designed for this range. After selecting the
correct backguard, the range must be installed
properly, using the minimum clearances to com-
bustible surfaces specified in the Cabinet Prepa-
ration instructions on pages 4 and 5.
WARNING
To avoid possible burn or fire hazard, a backguard
designed specifically for this range must be installed
whenever the range is used.
CAUTION
This unit is designed as a cooking appliance.
Based on safety considerations, never use it for
warming or heating a room.
Check local building codes for the proper method of
appliance installation. Local codes vary. Installation,
electrical connections and grounding must comply
with all applicable codes. In the absence of local
codes the appliance should be installed in accor-
dance with the National Fuel Gas Code ANSI Z223.1/
NFPA 54 current issue and National Electrical Code
ANSI/NFPA 70 -current issue. In Canada, installation
must be in accordance with the CAN 1-B149.1 and .2
– Installation Codes for Gas Burning Appliances and/
or local codes.
CAUTION
To eliminate risk of burns or fire caused by
reaching over heated surface units, cabinet
storage located above the surface units should
be avoided.
This appliance complies with one or more of the
following standards:
• UL 858, Standard for the Safety of Household
Electric Ranges
• UL 923, Standard for the Safety of Microwave
Cooking Appliances
• UL 507, Standard for the Safety of Electric Fans
• ANSI Z21.1, American National Standard for
Household Cooking Gas Appliances
• CAN/CSA-C22.2 No. 113-M1984 Fans and Venti-
lators
• CAN/CSA-C22.2 No. 61-M89 Household Cooking
Ranges
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
CAUTION
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with its own
high-pressure regulator in addition to the pressure
regulator supplied with the range. The maximum gas
pressure to this appliance must not exceed 14.0
inches water column (34.9 mb) from the propane
gas tank to the pressure regulator.
1