Filter
Top Products
English 2
Electrical Requirements
It is the personal responsibility and obligation of you, the
user, to have this appliance connected to the electrical
power supply by a qualified electrician, in accordance with
the National Electrical Code and/or applicable local codes
and ordinances.
All rangetop models require an electrical circuit rated at 120
volts, 60 Hz., 10 Amps, except models with electric griddle
require 15 Amp circuits.
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
See the Installation Manual for electrical requirements and
grounding instructions.
Safety Codes and Standards
This appliance complies with the following Standards:
• UL 858, The Standard for the Safety of Household
Electric Ranges
• ANSI Z21.1, The American National Standard for
Household Cooking Gas Appliances
• CAN 1-1.1-M81, Domestic Gas Ranges
• CSA C22.2 No. 61, Household Cooking Ranges
Check your local building codes for the proper method of
installation. In the absence of local codes, this unit should
be installed in accordance with the National Fuel Gas Code
No. Z223.1 current issue and the National Electrical Code
ANSI/NFPA No. 70 current issue or the Can - B149
Installation Codes for Gas Burning Appliances and C22.1
Canadian Electrical Code Part 1.
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
When properly cared for, your new THERMADOR
PROFESSIONAL
®
rangetop has been designed to be a
safe, reliable appliance. However, use extreme care when
using this restaurant caliber rangetop as this type of
appliance provides intense heat. When using kitchen
appliances, basic safety precautions must be followed,
including the following:
Read this Use and Care Guide carefully before using your
new rangetop to reduce the risk of fire, electrical shock, or
injury to persons.
Insure proper installation and servicing. Follow the
Installation Manual provided with this product. Have the
rangetop installed and electrically grounded by a qualified
technician.
Have the installer show you where the electric circuit
breaker and the gas supply shut off valve are located so
you know how and where to turn off the gas and electricity
to the rangetop.
In the event a STAR
®
burner goes out and gas escapes,
open a window or a door. DO NOT attempt to use the
rangetop until the gas has had time to dissipate. Wait at
least 5 minutes before using the rangetop.
DO NOT repair or replace any part of the appliance unless
specifically recommended in this manual. All servicing
should be referred to a qualified technician.
IMPORTANT SAFETY INSTRUCTIONS
Read and Save These Instructions
WARNING:
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON and
there is no electrical power to operate the electronic
igniters on the rangetop STAR
®
burners, turn OFF the
gas control knob and wait 5 minutes for the gas to
dissipate before lighting the STAR burner manually.
To light the STAR burners manually, carefully hold a
lighted match to the STAR burner ports and turn the gas
control knob to HI
. During a power failure, you can use
the standard rangetop STAR burners, but each must be
lit with a match.
DO NOT attempt to light the two left XLO
®
STAR
burners manually. These STAR burners are equipped
with the ExtraLow
®
feature and cannot be lit manually.
CAUTION:
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE CONNECTED TO A PROPERLY GROUNDED AND
POLARIZED ELECTRICAL POWER SUPPLY.