Filter
Top Products
1
GAS TYPE VERIFICATION
Verify the type of gas supplied to the location. Ensure
that the appliance is connected to the type of gas for
which it is certified. All models are certified for use with
natural gas. Field conversion of the appliance for use
with propane gas supply will require a conversion kit.
IMPORTANT
• A backguard must be utilized when there is less
than a 12” horizontal clearance between combus-
tible materials and the back edge of the range. The
Thermador Low Back backguard must be or-
dered separately and installed at the rear of the
range. For island installations and other installa-
tions with more than 12” clearance, an optional
stainless steel Island Trim is available to cover the
backguard mounting flanges.
• Verify that the appliance is correct for the type of
gas being provided. Refer to Step 5 on Page 12
before proceeding with the installation.
Gas Supply :
Natural Gas - 6 inch water column, (14.9 mb) min.,
14 inch (34.9 mb) maximum
Propane Gas - 11 inch water column, (27.4 mb), min.
14 inch (34.9 mb) maximum
Important Installation Information
This appliance complies with one or more of the follow-
ing standards:
• UL 858, Standard for the Safety of Household Elec-
tric Ranges
This appliance has been tested in accordance with
ANSI Z21.1, Standard for Household Cooking Appli-
ances (USA) and in accordance with CAN 1.1-M81
Domestic Gas Ranges (Canadian).
It is
strongly recommended that this appliance be
installed in conjunction with a suitable overhead
vent hood. (See Step 1 for Ventilation Require-
ments.) Due to the high heat capability of this unit,
particular attention should be paid to the hood and
duct work installation to assure it meets local building
codes.
Check local building codes for the proper method of
appliance installation. Local codes vary. Installation,
electrical connections and grounding must comply
with all applicable codes. In the absence of local
codes the appliance should be installed in accor-
dance with the National Fuel Gas Code ANSI Z223.1/
NFPA 54 current issue and National Electrical Code
ANSI/NFPA 70- current issue. In Canada, installation
must be in accordance with the CAN 1-B149.1 and .2
– Installation Codes for Gas Burning Appliances and/
or local codes.
CAUTION
To eliminate risk of burns or fire caused by
reaching over heated surface units, cabinet
storage located above the surface units
should be avoided.
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with its
own high pressure regulator in addition to the pres-
sure regulator supplied with the range. The maxi-
mum gas pressure to this appliance is not to
exceed 14.0 inches water column (34.9 mb)
from the propane gas tank to the regulator.
CAUTION:
This unit is designed as a cooking appliance.
Based on safety considerations, never use it for
warming or heating a room
.
CAUTION
This appliance is equipped with an intermittent/inter-
rupted ignition device that cycles the two far left surface
burners on and off when in the ExtraLow
®
setting.
• UL 923, Standard for the Safety of Microwave Cook-
ing Appliances
• UL 507, Standard for the Safety of Electric Fans
• ANSI Z21.1, American National Standard for House-
hold Cooking Gas Appliances
• CAN/CSA-C22.2 No. 113-M1984 Fans and Ventila-
tors
• CAN/CSA-C22.2 No. 61-M89 Household Cooking
Ranges
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Due to the high heat of the cooktop burners, installing
a microwave oven with a ventilation system over the
cooktop is not recommended.