Filter
Top Products
Accessible parts may
become hot when the grill
and/or griddle is in use.
Young children must be
kept away.
Gas and ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
Section One: GENERAL SAFETY INSTRUCTIONS
Safety Precautions
Save these instructions
It is the personal responsibility and obligation of you, the user, to have this
appliance connected to the electrical power supply in accordance with
the National Electrical Code and/or applicable local codes and ordinances
by a qualified electrician.
See Installation Instructions for electrical requirements and
grounding instructions.
ALWAYS DISCONNECT THE
ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
It is recommended that a
dedicated circuit servicing this
appliance be provided.
The use of gas cooking appliances
results in the production of heat
and moisture.
PLEASE READ CAREFULLY
30" Dual-Fuel Models:
240/208 volts, 60 Hz,
35 Amp electrical circuit required.
36" Dual-Fuel Models:
240/208 volts, 60 Hz,
35 Amp electrical circuit required.
If for any reason a gas control knob is turned ON and there is no
electrical power to operate the electronic igniters on the range's
cooktop burners, turn OFF the gas control knob and wait 5
minutes for the gas to dissipate before lighting the burner manu-
ally.
To light the burners manually, carefully hold a lighted match to the
burner ports and turn the gas control knob to HI. During a power
failure you can use the standard cooktop burners, but each must
be lit with a match.
DO NOT attempt to light the two left burners manually. These
burners are equipped with the ExtraLow
®
feature and cannot be lit
manually.
CAUTION - ALL MODELS
IN CASE OF AN ELECTRICAL FAILURE
FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE
CONNECTED TO A
PROPERLY GROUNDED
AND POLARIZED ELEC-
TRICAL POWER SUPPLY.
2
TESTED IN ACCORDANCE
WITH:
• ANSI Z21.1 for Household
Gas Appliances
• UL858 Edition for Household
Electric Ranges
• CAN/CSA-22.2 No. 61-M89 for
Household Cooking Ranges
• CAN/CGA 1.1-M81 Domestic
Gas Ranges
Check your local building codes
for the proper method of
installation. In the absence of local
codes, this unit should be installed
in accordance with the National
Fuel Gas Code No. Z223.1 current
issue and the National Electrical
Code ANSI/NFPA No. 70 current
issue or the Can - B149 Installation
Codes for Gas Burning
Appliances and C22.1 Canadian
Electrical Code Part 1.
It is the
responsibility of the owner and
the installer to determine if
additional requirements apply in
specific installations.
48" Dual-Fuel Models:
240/208 volts, 60 Hz.,
50 Amp electrical circuit required.
CAUTION
CAUTION
WARNING