Filter
Top Products
English 28
Toe Kick Panel (optional)
(PA [36,48] JTKG)
1. Remove the leg covers by sliding the top, outer sleeve
of the leg covers off the extruded dimples of the cast
aluminum base (see Figure 26 on page 27).
2. Remove protective plastic covering from the Toe Kick
Panel.
3. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the cast aluminum
base.
4. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive snap, letting you know that
the part has been installed.
5. Mount the Toe Kick Panel on both sides of the unit into
the extruded dimples using the (4) T-20 Torx drill point
screws provided.
Toe Kick Parts Included
(1) Toe Kick panel
(4) T-20 Torx drill point screws
(1) Installation Guide
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
Figure 28: Toe Kick Panel Installation
Mounting hole locations (x2)