Filter
Top Products
English 9
Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR
®
appliance
packaging material is recyclable. Never allow
children to play with packaging material.
3. All ranges are held to the pallet by (4) bolts through a
wood block center (see Figure 5). The two front pallet
bolts are accessible only after removing the Door
Trim located beneath the doors.
• The Door Trim is removed by loosening the 2
screws attaching it to the range and sliding it up
and off the screws.
4. After removing the pallet bolts using (2) 1/2” (13mm)
wrenches (one to hold bolt at the bottom while the
other is loosening the nut at the top) and discarding the
wood packing block inserts, the range may be carefully
tilted back on the (2) casters (see Figure 24 on
page 25) and removed from the pallet. Use additional
help as required to remove from pallet.
• Due to the weight, a furniture dolly with soft wheels or
an air lift should be used to move this unit. The weight
must be supported uniformly across the bottom (see
Figure 6).
• After transporting the range by dolly close to its final
location, the range can be tipped back and supported on
the rear casters while the dolly is carefully removed.
• “Step 5: Installing Anti-Tip Device”, “Step 6: Gas
Requirements and Hookup”, “Step 7: Electrical
Requirements, Connection & Grounding”, and
“Step 8: Backguard Installation (optional)” must be
completed before the range is placed in its final
position.
• Use the casters to assist with the installation near to its
final location. THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED BEFORE PUSHING THE
UNIT INTO POSITION.
Figure 5: Door Trim, Packing Blocks, & Pallet Bolts
Wood Packing Blocks
Pallet Bolts
Loosen Screws
Figure 6: Furniture Dolly Positioning
braces
22
3
/
4
” (578mm)
bottom of
Range must
be uniformly
supported by
provided on
range.