Filter
Top Products
English 19
Step 8: Backguard Installation
(optional)
Installation methods will vary upon need. Before you begin read these instructions carefully. Observe all local codes and
ordinances.
WARNING:
To reduce the risk of fire or injury to persons,
check to make sure all packaging has been
removed from accessory devices before use.
Backsplash Installation
(PA [30,36, 48] JBS)
The backsplash must be installed prior to installing an over-
head hood given that the hood shell covers the top mount-
ing screws of the backsplash.
• To protect against scratches, leave protective film on
backsplash until after installation is complete.
• If range is already installed, refer to the manufacture’s
instructions to disconnect gas and power supplies.
Move range forward to gain access to rear of unit.
1. Locate and lightly mark wall studs.
• Wall studs are usually installed with a 16” or 24”
(406mm or 1372mm) space on center.
2. The height of the hood will determine the height of the
top edge of the backsplash. The backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the backsplash 1
1
/
2
” (38mm).
3. Per each wall stud, use (2) of the provided screws to
secure both the top and bottom of the backsplash (see
Figure 16).
• Due to variable wall stud widths and varying
backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
Parts Included Tools Needed
(10) 1” (25.4mm)
screws
Phillips screwdriver or
drill
(1) Backsplash Tape measure
(1) Installation Guide Pencil
Figure 16: Backsplash Installation
W
all Studs
30”, 36”, 48”
(760mm, 913mm, 1218mm)
42” (1070mm)
Space screws evenly
across top & bottom