Filter
Top Products
SMW Oven Care and Use Manual
Lower Oven Maintenance
Do-It-Yourself Maintenance
Signals and Control Panel Display
OVEN TEMPERATURE CALIBRATION
Your oven has an electronic thermostat which
accurately maintains the selected temperature.
However, if foods generally over brown or under
brown in the cooking time given in your recipe, you
have the option to recalibrate the oven.
To recalibrate your oven, use the Bake pad
and number pad:
1. Touch Bake and then any number between 500°
to 550°F or 260° to 290°C.
2. Touch and hold Bake for 3 to 4 seconds. Display
will show 00º for 4 to 5 seconds.
3. Enter desired temperature from plus or minus 0°
to 35°F in 5°F increments (0° to 21°C in 3°C
increments).
4. By touching Broil repeatedly, it will toggle between
positive and negative degrees (–) for the increment
entered.
5. Press OFF to exit this calibration mode or it will
cancel automatically.
Notes:
1. You can verify your new calibration by repeating
the above procedure.
2. If you first put in -5°F and then want to drop the
temperature an additional -5°F, put in -10°F the
second time you recalibrate. The numbers entered
are not cumulative.
Clock / Timer Priorities:
• Timers have the first priority in the window
display. If a timer is in use, the clock can only be
viewed by touching the CLOCK pad.
• If two timers are being used, the one with the
shortest time will have the priority. If
TIMER 1
is in use with 10 minutes remaining and TIMER
2 is in use with 5 minutes remaining, TIMER 2
will be displayed.
TIMER 1
or the Time of Day
may be viewed by touching the TIMER 2 or
CLOCK pad.
TIMER 1
or the Time of Day will
display briefly and then return to TIMER 2
countdown.
Chimes / Beeps
• A chime sound is used to designate feedback for
programming, the end of a timing or cooking
operation.
• A beep sound is used to designate an incorrect
entry, door is open when set for
Self Clean mode,
or as a fault indicator.
Window Display Area Shows the Following:
• Time of Day
• Countdown of time remaining when using timed
mode.
• Temperature of oven as it rises to reach
programed temperature and the set temperature
once it is reached.
• Recall programmed temperature or time when
Clock, Bake, Convection, Convection Roast, Broil,
Timer 1 or Timer 2, Start Time, and Stop Time
are touched.
• Rounding of display numbers. Temperature ranges
from 100° to 550°F (38º to 290ºC) and can be set
at any number in that range. In the Fahrenheit
display, the display will round to the closest 5°F,
Example: 348° will round the temperature to
350°F.
• 1 and 2 to show which Timer is set.
Page 56
IF CONNECTING TO 208/120 VOLTS
This oven can be connected to a 208/120 volt or 240/120 volt power source. When
connected to a 208/120 volt power source, optimum results are achieved in Bake,
Convection Bake and Convection by preheating the oven. Do not preheat the oven
in Broil. In Convection Roast it is not necessary to preheat. All timings may be longer
than those shown in the Baking Charts. The Self-Clean mode may need a longer clean
time than normal, depending on the amount of soil.