Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
8
8
Final Location
A. Place styrofoam corners behind cooler for cushion
and carefully tilt unit on it’s back.
B. Remove the louvered grill by removing four
phillips-head screws.
C. Remove the four bolts from the skid with an
adjustable wrench, and locate the four castors. Castors
are placed inside cooler, within the bubble wrap.
D. Install one castor in each of the four female threaded
areas as indicated.
NOTE: Two out of the four castors are designated
with an “F” for front. These are provided with
hand-brakes. Position these castors in FRONT of
the unit.
E. When all castors have been threaded fully, replace
grill and lift unit; positioning it into its final location.
F. Ensure that the two front castors are positioned
FORWARD as illustrated and locked down with the
hand-brakes.
WARNING:
Unit may tip forward if procedure “F” is not
strictly followed.
G. Units final location should be adequately ventilated.
Conditions where heat exceeds 100ºF require an
exhaust fan.
H. Ensure that the drain hose for hoses are positioned
in the pan.
I. Free plug and cord from inside the lower rear of the
cooler (Do Not Plug In.)
WARNING:
Warranty is VOID if ventilation is insufficient.
J. The unit should be placed close enough to the
electrical supply so that extension cords are NEVER
used.
WARNING:
Compressor warranties are void if the unit is more
than 6 1/2ft. (1.98m) from plug-in connection.
K. Proper leveling of your TRUE cooler is critical to
operating success. Effective condensate removal and
door operation will be effected by leveling. Adjust
castors or add shims.
INSTALLING OPTIONAL CASTORS ON A T-12FG
INSTALLATION / OPERATION INSTRUCTIONS
POSITIONING OF THE
CASTOR IS CRITICAL.
ORIENT THE CASTOR IN
THE FORWARD POSITION
AS SHOWN