Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
16
16
INSTALLATION / OPERATION INSTRUCTIONS
REQUIRED TOOLS
• none
STEP 1
Locate rubber gasket behind lamp holder
mounted to evaporator housing. (See
Image 1).
STEP 2
Fit the bottom edge of the lamp cover
into the bottom groove of the rubber
gasket and rotate upwards while
working the edges into the rest of the
rectangular groove. (See Images 2-3).
(slide fingers underneath top edges of
rubber gasket and push rubber over the
top lip of the lamp shield)
STEP 3
Be sure lamp cover is seated properly in
rubber gasket.
- IMPORTANT -
Before replacing light cover
turn cabinet on and wait until it
reaches temperature.
- NOTE -
If cabinet is turned off and
interior allowed to warm up
lamp cover may become loose
and require reinstallation.
Follow directions above.
- IMPORTANT -
Before replacing light cover
turn cabinet on and wait until it
reaches temperature.
- IMPORTANT -
Before installing lamp cover
turn cabinet on and allow it to
reach temperature.
Rubber Gasket
Lamp Holder
Lamp Cover
3
2
1
Light Cover Installation for T-12FG