Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
8 8
INSTALLATION INSTRUCTIONS FOR OPTIONAL
LID LOCK KIT FOR TDC MODELS ONLY.
INSTALLATION / OPERATION INSTRUCTIONS
REQUIRED TOOLS
• Drill
• 5/16” inch drill bit
• Padlock
STEP 1
Slide lock bracket under stainless steel
trim near center of lid. (See image
1). Mark the hole location of the lock
bracket on the Dipping cabinet handle.
STEP 2
Remove the lock bracket after marking
the hole location. Then drill 5/16”
diameter hole centered on back of the
Dipping cabinet aluminum handle.
(See image 3 & illustrations below).
STEP 3
Reinstall the lock bracket. Slip the
hooked end of the lock bracket under
the stainless steel top (See image 4).
Pull out and up to allow the lock
bracket to pass over the aluminum
handle. Place a padlock through the
lock bracket and handle.
(See image 5).
A
Lock Bracket
Drill Hole Centered on
Handle
Lock Bracket Centered
Image 1 (TDC Lock Bracket)
Image 2
Image 3 (Drilling lock bracket hole)
Image 4
Image 5
Bracket Part # 913544
Bracket Part # 913544