Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
13
13
MAINTENANCE, CARE & CLEANING
CLEANING: (Before cleaning out the interior locate the
drain hose in the rear grill area and be prepared
to open the line and drain the water into a pan
or floor drain. This will be the same for TDC and
THDC models)
The lid can be removed from the cabinet. (See
image 1 for TDC models and image 2 for THDC
models). If the lid has been removed, wash it with
nonabrasive soap or detergent and water. Use the
bare hand to feel and dislodge any caked soil. Rinse
thoroughly with clean water. Do not use hard,
rough cloths that will scratch the surface of the lid.
Dry with a clean, damp chamois. The interior can
be cleaned but, before doing so make sure the drain
at the bottom of the cabinet is open and the drain
hose in the rear grill is at a floor drain.
MAGNETIC ICE BREAKER (ONLY ON TDC MODELS):
Magnetic ice breaker were designed to provide a
fast and effective way to remove the frost from the
wall above the product. Frost accumulation
reduces the refrigeration effectiveness as it
increases in thickness.
The frequency at which to clean the ice breaker is
a function of the store operation as a starting point.
Thaw and clean at the beginning of each day. Thaw
under warm water or on a counter top at room
temperature until ice breaker is flexible and clear of
frost. Wipe dry to prevent returning moisture to
cabinet.
NOTE:
Magnetic ice breakers are soft and flexible at
room temperature but, they will become
relatively rigid when they have been exposed to
low temperature from the cabinet.
DO NOT FOLD MAGNETIC ICE BREAKERS!
Reinstall the ice breakers by forming around
corners. The ice breakers are magnetic and they
will attach tightly to the wall and resist sliding in
place. To overcome this apply from one end and
roll into place. (See image 3).
MAINTENANCE CLEANING
Image 1. The lid on TDC models can be removed
by lifting it out of the hinge bracket.
Hinge Bracket
Image 3. (ONLY FOR TDC MODELS).
Magnetic Frost Shield
Image 2. The lid can be removed by simply
lifting it out.