Filter
Top Products
26
Design
■
Features
■
Performance
LED Status Meaning
1 Solid Refrigerator Temperature displayed
Flashing Not Applicable
2 Solid Service Menu – wait 10 seconds and it will exit
automatically
Flashing Open thermistor – Refer to Thermistors.
3 Solid Service Menu – wait 10 seconds and it will exit
automatically (bin temperature displayed)
Flashing Drain Pump has been blocked or pump is
overloaded check installation and drain line
Note: If either of the flashing alerts (2 or 3) have been activated, power must be disconnected to the unit
either by unplugging or tripping the breaker to reset LEDs.
SERVICING
1. Be sure the cycle selector switch (located in the lower right side of the grille) is set to “ON”.
Display can be on when selector switch is “OFF”.
2. The controller will be set at the default setting of 38°F when it is first powered up. This
setting will display on the LED and should satisfy most customer applications.
IMPORTANT