Filter
Top Products
9
The time-of-day can be changed by following steps 1 through 3. It cannot
be changed while there is a Bake Hours or Start Time cycle programmed
into the timer.
SSeettttiinngg tthhee MMIINN//SSEECC TTiimmeerr
The MIN/SEC Timer is designed for accurate timing and is ideal for baking
delicate items such as biscuits, cookies, and popovers, and for precise
broiling. The MIN/SEC timer can be used at the same time the Bake Hours
or Start Time functions are in use. It can be used for timing up to 24 hours.
When setting the Timer, the time displayed will increase in 1 minute
increments. When the Timer counts down to 1 minute, the timer alarm will
give two short beeps and the display changes from hours:minutes to
seconds only.
TToo pprrooggrraamm tthhee MMIINN//SSEECC TTiimmeerr
1. Press the MIN/SEC Timer button. The timer will display :00 and the
word timer will be displayed in the lower right corner.
2. Turn the Set Knob until the desired duration time is displayed.
The Timer is now programmed. The alarm will sound at the end of the
countdown. The program can be canceled anytime by setting the
remaining time to :00. To change back to the time-of-day, press the
CLOCK button. Notice that a small clock will be displayed in the upper
right corner to indicate that a program is in progress. The display will return
automatically to the MIN/SEC Timer after a few seconds.
TTiimmeerr AAllaarrmm
At the end of a MIN/SEC Timer program or Bake Hours program, the alarm
will consist of three beeps followed by two beeps every 10 seconds until
the MIN/SEC Timer button is pressed. Whenever a valid function key is
pressed or when a control function starts automatically, one beep will be
sounded. When an invalid function key is pressed, two beeps will be
sounded.
8
UUssiinngg YYoouurr OOvveenn
EElleeccttrroonniicc TTiimmiinngg CCeenntteerr ((DDiiggiittaall DDiissppllaayy))
The Electronic Timing Center is used to program and control all timing
functions. Depending on the model, your unit will have a digital display or
an analog clock with digital display. If your unit has an analog clock, refer to
pages 13-16.
It has five display and programming modes that are activated by the four
push buttons and the Set Knob. Both the Bake Hours mode and the
MIN/SEC Timer mode can be used to time cooking periods. These
features can even be used at the same time when both ovens are in use.
However, only Bake Hours and Self-Cleaning modes shut the oven off
automatically when the timed program is over. For example, you can time
bake a casserole in the upper oven using the Bake Hours mode, while
broiling in the lower oven using the MIN/SEC Timer. One oven can also be
cleaned while timing foods in the other oven using the MIN/SEC Timer.
SSeettttiinngg tthhee TTiimmee--ooff--DDaayy
The time-of-day must be set before any other program can be used. When
your oven is first connected to the power in your home, the timer display
will show --:--. To program the time-of-day:
1. Press the CLOCK button. 12:00 will be displayed with the word set in
the upper right corner.
2. Turn the Set Knob until the correct time-of-day is displayed. AM and PM
are not indicated.
3. Press the CLOCK button again. The word set will disappear and the
correct time is now set into the timer.